Basic Info. |
Model NO. | MPP Pipe |
Material | PP |
Kind | Thermoplastics Pipes |
Executive Standard | Dl/T802.7-2010 |
Mop | Within 2.0 MPa |
Ash Content | Winthin 0.1% |
Color | Usually Orange |
Transport Package | Coated or Bare Pipe Transportation |
Specification | 5.8m, 6m, 12m or on customer requests. |
Trademark | Jinhong |
Diameter | 50mm-250mm |
Thickness | 5.0mm-15.0mm |
Outer Diameter | 50mm-250mm |
Ring Stiffness | Sn24-Sn32-Sn40 |
Temperature Resistance | -5ºC~70ºC |
Using Life | Over 50 Years |
Origin | China |
HS Code | 3917390000 |
Production Capacity | 30, 000 Tons /Year |
Product Parameters
MPP Cable Conduit Pipe's Parameter Datas |
Norminal Lenght (mm), Ring Stiffness (3%) Grade (Normal Temperature) |
Nominal diameter (mm) | Norminal Wall Thickness (mm) |
SN24 | SN32 | SN40 |
100 | 6 | 8 | 10 |
125 | 8 | 10 | 12 |
150 | 10 | 12 | 14 |
175 | 12 | 14 | 16 |
200 | 14 | 16 | 18 |
225 | 16 | 18 | 20 |
250 | 18 | 20 | 22 |
Note:
1. This series of pipes are mainly used in MPP electric power pipe. The nominal pressure refers to the maximum allowable working pressure of the pipe conveying water at 20ºC.
2. The weight of the above table is calculated according to the average density of 0.95g/cm³, and the outer diameter and wall thickness are taken as the nominal value plus half of the limit deviation.
Production features
1. MPP pipe has excellent electrical insulation.
2. MPP pipe has higher thermal deformation temperature and low temperature impact performance.
3. MPP pipe has higher tensile and compression resistance than HDPE.
4. MPP pipe is light, smooth, frictional resistance is small, can be hot-melt butt joint.
5. MPP tube long-term use temperature-5 ~ 70 ºC.
6. Construction instructions:
1) It is strictly forbidden to drop, hit, scratch, or expose to the sun during the transportation and construction of pipes.
2) The axis of the two pipes must be aligned during the hot-melt butt joint, and the end face cutting should be vertical and flat.
3) The processing temperature, time, pressure, and climate conditions are adjusted accordingly.
4) The minimum bending radius of the pipe should be ≥75 pipe outer diameter.
